Author: Sridhar Condoor
Edition:
Binding: Spiral-bound
ISBN: 1585033111
Edition:
Binding: Spiral-bound
ISBN: 1585033111
Modeling with Pro/ENGINEER Wildfire 3.0
This book synergistically integrates the design process with the specific commands and procedures of Pro|ENGINEER through a unique presentation scheme. Get Modeling with Pro/ENGINEER Wildfire 3.0 computer books for free.
Users are first provided with the design information about the part or assembly and its design intent. Then, they see the sequence of steps involved in modeling the part/assembly. Detailed instructions are provided in a four-column presentation showing goals, steps and commands. The consistent approach is supplemented by many illustrations on each page. Each chapter adds new information while reinforcing key concepts. Table of Contents 1. Introduction
2. Bearings
3. Bearings
4. Bushing
5. Retaining Ring
6. Shaft
7. Shaft Drawing
8. Nuts and Bolts Check Modeling with Pro/ENGINEER Wildfire 3.0 our best computer books for 2013. All books are available in pdf format and downloadable from rapidshare, 4shared, and mediafire.
Modeling with Pro/ENGINEER Wildfire 3.0 Free
Users are first provided with the design information about the part or assembly and its design intent. Then, they see the sequence of steps involved in modeling the part/assembly. Detailed instructions are provided in a four-column presentation showing goals, steps and commands. The consistent approach is supplemented by many illustrations on each page Nuts and Bolts
No comments:
Post a Comment